Blog

I want a panic push bar for a single timber door, but we also require to gain access from the outside using a lock with key. What do you recommend?

By Door Admin / 25 January 2012

Depending on the answer to this question; Do you want the door to lock behind you, after you’ve entered with the key OR do you want to have to re-lock it with the key?  If you want it lock automatically, then we’d recommend an Exidor 305 mortice operator(opens in new tab), which comes with a…

Would the T2024 door closer be OK for a light (1″ thick) pine bedroom door?

By Door Admin / 24 January 2012

General door closers usually come in fixed power size 3, which ensures they are strong enough to meet fire regulations for closing large fire doors up to about 900mm wide.  If this is the type you’ve previously fitted, then the fixed power size is your problem – this makes them too strong for children and…

The TS1500 door closer is what we seem keen on for our door pictured on my Flickr page, though I’m a little worried it will be an eyesore:-

By Door Admin / 19 January 2012

A TS1500 is a good choice and can be dressed up with a matching cover & arm in polished brass for example.  Having a close look at the photo, we would like to suggest perhaps fitting the closer in the “Figure 66” position on the other side of the door.  This is because there is…

In a building in an exposed coastal location, what would be the best hinges for external doors?

By Door Admin / 19 January 2012

The best material to use is a hinge made of brass plated with polished chrome.  Brass is a highly corrosion-resistant material, which is why it’s used a lot in boats.  However, it does tarnish and the surface of raw brass will naturally begin to look green and unpleasant over time, without the body of the…

Could you tell me the hole diameters required through the glass for the back to back guardsman handles 450mm centres x 700mm x 25mm bar?

By Door Admin / 19 January 2012

The bolt is threaded M8, then over that is a plastic sleeve to protect the glass of approximately 2 – 3 mm thickness.  We always advise that you don’t drill glass until you have the fasteners in hand, so you can check the exact dimensions yourself.

I am looking for some tracking to fit four 30″ wardrobe sliding doors. Do you have any, I need it in one length?

By Door Admin / 15 January 2012

With 4 wardrobe doors of 30″ width, I estimate you’re looking for about 3 metres of track. The SAHECO SF-30 or SAHECO SF-53 would be the best systems – which one will depend upon the weight of the doors, they both come up in a variety of kit / track lengths.  You might go for…

I am looking for a door closer for our fire door that goes from utility room to the integral garage, currently it operates with a spring loaded device (not adjustable) that slams the door shut with a big bang. Can you recommend a door closer which would close the door without slamming it shut?

By Door Admin / 15 January 2012

An overhead hydraulic door closer would be a good solution for your slamming problem.  For a large fire door (and width is the most important dimension to consider) you might go for a medium to heavy duty door closer(opens in new tab) like the GEZE TS4000 or the TS2000NV.  For a narrower door; the domestic…

I need to fit a door closer on my shop door. Our location is close to the sea in Cornwall and the door in question is facing the sea so the wind is an issue. The closer does not need to be so strong that customers think we are closed but I do need the door to close automatically behind them. When the door opens it goes back against a wall. Please advise!

By Door Admin / 11 January 2012

The door closer we would recommend for your scenario would be the Geze TS4000.  It is fully adjustable in power size, so you’ll be able to set it up to operate exactly as you want it, and it’s easy to do – so you can personally set it to high power during windy spells and reduce the power…

What are the dimensions of the Exidor 297 push pad?

By Door Admin / 11 January 2012

The Exidor 297 is 159mm tall x 55mm wide x 80mm projecting.  You can see dimensioned diagrams, plus loads of other info on the pdf at this link(opens in new tab) (pdf’s towards the bottom of the page). (opens in new tab)(opens in new tab)

Your frameless glass pull handles, can they be used on 6mm thick glass/polycarbonate?

By Door Admin / 10 January 2012

They are suitable only for glass (or polycarbonate) of 8, 10 or 12mm thickness, or somewhere in between, and would not tighten enough to use on 6mm thickness.

I am looking for interior door locks for the doors in my house to help control room access to my autistic son. Can you advise me please?

By Door Admin / 8 January 2012

We can suggest using “keyed alike” 3 lever locks on your internal doors – this would mean you would only need to carry around one key and it would operate all the locks (although they come with 2 keys each, the keys are all the same).  You may want to look at compatible door handles…

Can I replace this Exidor 285 rebated double door panic hardware?

By Door Admin / 7 January 2012

This photo shows an obsolete Exidor 285 push bar(opens in new tab) for double rebated fire escape doors(opens in new tab).  The obvious identifying feature is the offset touching push bars, angled at the conjunction.  To replace a set like this, order our Exidor 296-4(opens in new tab), which comes with the appropriate keep for…

What Sliding Door Goes Seamlessly Back into the Wall?

By Door Admin / 7 January 2012

From this description, it sounds as if you’re looking for a pocket door system, where the door slides back into a cavity in the stud walling like this photo?  We supply two different basic designs of pocket doors – the Hideaway and the iMpero.  You can have a look at them on our website at the…

How much wall space does a Hideaway need?

By Door Admin / 7 January 2012

Q: I’ve ordered a Hideaway pocket door system today, but before it arrives tomorrow I need to know how much space to leave in my wall for the whole thing to fit in? A: You need to allow 2 x (door width) + 1 inch.

Is the outside access device 322EC compatible with the Exidor pushbar 296-4?

By Door Admin / 28 December 2011

Yes those units are compatible with each other, you only need one 322EC for the double door set.

Secret POCKET DOOR discovered in Skyrim!

By Door Admin / 23 December 2011

As a bit of Christmas fun, we thought we’d share the discovery of a secret POCKET DOOR behind a wardrobe in the Sleeping Giant Inn, Riverwood, Skyrim.  To find it you’ll have to be on the quest for the “Horn of Jurgen Windcaller”, but if you fancy having one in your own worldly abode, you…

Introducing the Terra 120G bottom rolling sliding door gear for frameless glass

By Door Admin / 22 December 2011

  An Italian style designer bottom rolling sliding door kit for frameless glass doors. The satin stainless steel half-moon shaped track comes pre-drilled in 2m and 4m lengths and can be cut down. Rubber covered rollers give a smooth quiet action. The sliding door kit comes complete with track, single wheel rollers, full length top…

Q: I have a door that is a glass panel at the top. The wood above the glass to the door stop is approx 73mm. The door opens outwards. The door is on a warehouse and is used quite a lot by the public. I have brought 2 closers from my local DIY centre but they do not fit due to the narrow bit at the top. What do you recommend?

By Door Admin / 22 December 2011

A: There are two possible solutions; Option 1.) Using a door closer with a Drop Plate, e.g. the Geze TS2000NVBC (which is a really good mid-range, mid-price model) – the drop plate (shown above) allows the body to be set lower than the fixing positions, over the glass in this case, and it is an extra £18.00…

What products can be used under the EN 179 standard?

By Door Admin / 13 December 2011

EN 179 covers panic hardware Push Pads and Lever Handle devices, which can be used in areas were members of the public do not have access, such as workplace offices or factories. The standard allows these types of products to be used in areas were users will be familiar with the means of escape and…

Fixed panel / sliding panel for frameless glass

By Door Admin / 26 November 2011

We are proud to announce stock has arrived of Geze Perlan Fixed panel / sliding panel gear for frameless glass. Ideal for use as office partition doors, retail office areas, and in the home as a modern room divider. Sold as standard in 3m long kits to accomodate one sliding panel and one fixed panel, but easily…

Please advise on the sliding folding doors we want to use them on external 3 x 4m is there a way of waterproofing them? And can these be without wood, just glass?

By Door Admin / 21 November 2011

The only door kits we do which include weather seals for external doors are the TIWI sliding & folding doors.  However it is for timber framed doors only, glazed is OK.  We don’t know of a standard kit for this job, we think you’ll have more luck with a bespoke architectural glass supplier.